Contents of the full kit 15 items and 4 pads
Items marked with an * are self-adhesive and should be applied to a clean and dry surface only. We recommend the use of a small roller to apply even pressure.
1-3 * – These items adhere to the recesses under the bonnet lid, by their shape.
4&5* – These items adhere to the bulkhead. Item 4 to the centre bulkhead and item 5 to the passenger side bulkhead
INTERIOR OF VEHICLE
6&7 – Remove the carpet kick strips by the doorsills and lift the carpets to gain access to the footwells. Place these items under the carpets in the front footwells. These items fit under the front floor carpets. Item 6 to the drivers side and item 7 passenger side.
8&9 – Follow the same procedure as for the front floors but fit these items to the rear floors and under the rear of the front seats. Item 8 driver side, item 9 passenger side
10 – Place item 10 under the rear seats.
11&12* – These items adhere to the rear wheel arches into the boot area.
Remove manufacturers covers (if fitted to your model) and fit the items directly on the wheel arch. Item 11 drivers side and item 12 passenger side. Re-fit the covers over the soundproofing.
13* – This items adheres to the drivers side rear wing
14* – Place item 14 under the spare wheel.
15 – Place item 15 on the boot floor under the existing carpet.
Remove the interior door trim panels and fit the pads to a clean surface on the door skin. Re-fit the interior trim panels.
The Fitting is now Complete