Jeep Wrangler 1997 Onwards
JEEP WRANGLER 1997 onwards
Contents of the full kit 17 items and 17 pads
Items marked with an * are self-adhesive and should be applied to a clean and dry surface only we recommend the use of a small roller to apply even pressure.
1 & 2* Fit these items to the bonnet lid
3 & 4* These items fit to the bulkhead at the back of the engine item No 3 to the drivers side centre bulkhead 4 to the passenger side centre
Pads Fit three pads around the driver’s side-wheel arch and suspension tower. Fit one pad to the passenger side-wheel arch. Fit one pad to the outer wing driver’s side and one pad to the passenger side outer wing behind the battery.
Interior Cab section
5 & 6* Fit these items to the sidewalls of the foot well on the outer skin of the body. 5 to the driver’s side.
Pads Fit one pad on the floor area under the carpet
Fit three pads around the bell housing at the top of the transmission tunnel
7 & 8 Place pad No 7 under the front floor carpet driver’s side 8 under the passenger side
9 & 10 Fit these items to the side walls of the transmission tunnel 9 to the drivers side
Pads Fit one pad in the rear footwells
Fit one pad onto the rear wall bulkhead in each foot well
11 & 12 These items fit under the rear foot well carpet
13* Adhere item 13 to the metal covering in the boot floor.
14 & 15* Fit these items to the rear wheel arch rear section 14 to the drivers side
16 & 17* Fit these items to the front section of the rear wheel arches 16 to the drivers side
Loosen the door trim and fit one pad to the outer skin of each door
YOUR FITTING IS NOW COMPLETE