Mazda 121 1996 Onwards
Mazda 121 1996 Onwards
Fitting Instructions
Contents of the full kit 20 items plus 4 pads
Items marked with an * are self-adhesive and should be applied to a clean and dry surface only. We recommend the use of a small roller to apply even pressure.
ENGINE COMPARTMENT
1-6* Remove the manufacturers underbonnet cover (if fitted to your model). Items 1-6 adhere to the recesses under the bonnet lid by their shape. Re-fit the manufacturers cover over the soundproofing (if applicable)
7* This item fits to the driver’s side inner wing in the engine bay
8-9* These items fit to the passenger side inner wing and the side of the suspension tower. Item 8 to the lower section and item 9 above.
10-11* These items fit to the driver’s side suspension tower. Item 10 to the top/side of the tower and item 11 to the actual top of the tower.
12* This item fits to the actual top of the passenger side suspension tower
INTERIOR OF VEHICLE
13-14 Remove the carpet kick strips by the door sills and lift the carpets to gain access to the floors. Items are to be placed under the front floor carpets 13 to the driver’s side 14 to the passenger side.
15&16 Follow the same procedure and place these items under the carpets in the rear passenger foot wells. Item 15 to the driver’s side and 16 to the passenger side.
17 Place item 17 under the rear seats
BOOT COMPARTMENT
18-19* Remove the manufacturers wheel arch covers in the boot area (if fitted to your model) and these adhere to the actual wheel arch. Item 18 to the passenger side and 19 to the driver’s side. Re-fit the wheel arch covers (if applicable)
20 Place item 20 under the boot floor covering
DOOR PADS
Remove the interior door trim panels and fit the door pads to a clean surface on the inner skin of each door. Warm the pads before fitting to ensure a good contact with the door surface. Re-fit the interior panels
YOUR FITTING IS NOW COMPLETE