Contents of the full kit 16items and 21 pads
Items marked with an * are self-adhesive and should be applied to a clean and dry surface only. We recommend the use of a small roller to apply even pressure
INTERIOR OF VEHICLE
1 & 2 Undo the carpet kick strip by the driver side door and slide this pad under the carpet item 2 fits along the side of the transmission tunnel
3 & 4 These pads fit on the passenger side front floors as item 1 & 2
5 & 6 Follow the same procedure as for the front floors but fit these items under the carpets in the rear footwells.
7 Place this item under the rear seat
8* Remove the rear wheel arch covers and adhere this item to the drivers side wheel arch.
1Pad Also adhere 1 pad to the upper section of the wheel arch ( as marked on Piece no 8)
9* This piece adheres to the passenger side wheel arch
2 Pads Adhere a pad to the top and bottom of the wheel arch (as marked on Piece No 9 )
10* Remove the spare wheel and adhere this pad onto the floor under the spare wheel.
4 pads Adhere these four pads around the sides of the spare wheel well
11* Adhere this piece to the area at the back of the spare wheel well
10 Pads Adhere 4 pads to the side walls of the spare wheel well and further pads should be adhered the areas of the boot floor ( 6 pads are included for this purpose)
12 This large pad goes under the rear boot carpet and above the spare wheel
13 –16* These adhere to the boot lid
4 pads Remove the door trim and fit a pad to the outer skin of each door.
The Fitting is now Complete