VW T4 Rear Section Kit
VW T4 REAR SECTION KIT
14 items & 30 Pads
Items marked with an * are self-adhesive and should be applied to a clean and dry surface only. We recommend the use of a small roller to apply even pressure.
Roof Unclip the roof headliner be careful with the light connectors
10* This piece adheres to the roof in the section nearest to the front.
11* This piece adheres next along the roof.
12* This piece adheres to the roof third section.
13* This piece adheres to the rear roof section.
Side Panels Upper side panels
14* & 15* These adhere to the front upper side panels where the windows would have been (if you have windows these won’t be included).
16* & 17* These adhere to the rear upper side panels where the windows would have been (if you have windows these won’t be included).
Lower side panels and side doors
Barrier Mat Pads Unclip the door cards/panels covering this area and adhere the pads to the
outer skin evenly spacing them. There are 30 Barrier Mat Pads included, sized at 250mm x 165mm or 10” x 6 ½”. In some smaller areas you may need to cut the pads down to smaller sizes.
Rear Wheel arches
18* & 19* These adhere to the face of the rear wheel arch. 18 to the driver’s side.
20* & 21* These adhere to the top of the wheel arch. 20 to the driver’s side.
FOIL TAPE Use this to run along the joint line to make it look neater.
Rear Floor
22 Fit this piece onto the floor under the rubber matting. You will need to mark and cut out for any floor brackets.
23 Fit this piece to the rear of piece number 22.
(An off cut piece will be provided to cover any smaller areas on the floor not covered by 22&23).
The fitting is now complete, happy motoring!!!