Contents of the full kit 17 items and 8 pads
Items marked with an * are self-adhesive and should be applied to a clean and dry surface only. We recommend the use of a small roller to apply even pressure.
1-6 * Remove the manufacturers cover and fit these items to the bonnet lid by their shape. Re-fit cover.
7 * This item adheres to the passenger side bulkhead.
INTERIOR OF VEHICLE
8 – 9 Lift the carpet kick strip by the doors and slide these pads under the front carpet and to the sidewalls of the transmission tunnel. Item 8 driver’s side and item 9 passenger side.
10 -11 These items fit under the carpet in the front floors. Item 10 driver’s side and item 11 passenger side.
12 -13 Follow the same procedure as for the front floors. Fit these items under the carpets in the rear footwells and also under the rear of the front seats. Item 12 passenger side and item 13 driver’s side.
14 Place item 14 under the rear seats.
REAR DECK AREA
15-16* These items adhere to the rear wheel arches. It will be necessary to remove the wheel arch covers and to re-fit them over the soundproofing.
17 Place item 17 under the spare wheel.
18 Place item 18 on the boot floor above the spare wheel.
Fit one pad to the outer skin of each door after removing the door trim.
Re-fit the interior door trim panels.
The fitting is now complete.